How to apply Plenty Mani semi-cured gel nail ?
Just a few simple steps to a spectacular DIY manicure!
All you need is included in the box.
1. Prepare your nails
Push back cuticles with the wood stick and shape nails with a nail file.
2. Measure and apply
**There are 10 different sizes to suit all nails. **
To determine which strip to use, place your nail under the strips. Choose the one that fits the width of your nail.
Center the gel strip on your nail and paste on gently.Avoid sticking it on your skin or cuticles.
You can peel off and reposition the strip if needed.
Use the wooden cuticle stick to apply pressure firmly on the edges of the gel strip, make sure that it is fully flattened and adhered.
This is to prevent the edges from sticking up after curing.
3. Cure the gel wraps
Cure the gel wraps under a UV lamp for 60 seconds so it can harden.
4. Trim and file away excess
Use a nail clipper to clip off most of the excess gel wrap.
Clip as close to your nail as possible, but don't worry if it isn't shaped perfectly! You can continue to shape nails in the next step.
Use a nail file to file off any excess gel wrap, and to shape the gel wraps.
How do I remove semi-cured gel?
Wet a wooden cuticle stick with nail polish remover then start to loosen the edges of your gel wrap.
Clean nails and apply cuticle oil if necessary.
Pro Tips!
Perfect size
The 10 different nail wrap sizes are made to fit all nails.
If you're in between sizes, pick the size that's slightly smaller and gently stretch it to fit.
BOGO
Short nails? Cut the strips in half to double your manicure!
Seamless finish
File at an angle under the nail, instead of above it, to get a seamless finish.
Store remaining strips
- Do you have any strips left?
Replace them in the envelope and seal the edge with a low-temperature flat iron.
- You can use the remaining strips for a pedicure.
- For a matching manicure on your children's little fingers!